Zhejiang Oulun Electric Co., Ltd

Add: No.17 Tangmei Road, Yuhang Economic Development Zone, Yuhang District, Hangzhou, Zhejiang, China

Contact us: Lily Shen

Tel: 86-571-89301300

Mobile: 86-15957119041

Email: sales8@oulungroup.com

Home > Exhibitions > Content
The application of the humidifying system of the electronic factory
Dec 21, 2017

Selection of humidifiers for different types of electronic building

1. For an electronic plant with a central air conditioning unit and a humidifying section in the unit:

1. if the user wants the air conditioning with a higher air supply temperature and a higher adjustment precision:

L) a special ultrasonic humidifier for central air conditioning is recommended if the user is inconvenient to use steam or steam.

2) if the user has a steam source and is convenient to use, it is recommended to use a dry steam humidifier!

2. if the user wants the air conditioning to provide only a general humidification and a low humidification requirement, a hygienic requirement is required.

At the same time:

It is recommended to use wet film direct drainage humidifier!

Note: 1) the air conditioning unit with the air volume less than 10000m3h is recommended for wetting due to the smaller size of the humidifying section.

Membrane water board humidification method;

The air conditioning unit with air volume greater than 10000m3h is recommended to use wet film direct drainage and humidification.

2) because of wet membrane water drainage and humidification way, water resources waste too much, so it is not recommended that users use wet film straight line.

Water is like a wave!

3. if the user wants the air conditioning humidifying health conditions high and the user can provide pure water:

It is suggested that the users adopt ultrasonic atomization humidifying and humidifying method

Note: the ultrasonic atomizing and humidifying way is different from the traditional high pressure spray and humidification way! The ultrasonic atomizing humidifier has more than 90% humidification efficiency.

High pressure spray, the humidification efficiency is only about 30%.

Two. For a user with a central air conditioning unit, no humidification section but a air supply pipe and would like to be humidified in the air duct:

Recommend users to adopt:

L) special ultrasonic humidifier for central air conditioning

2) the way of dry steam humidification of the wind pipe (the condition is that the user has the steam source)!

Three. Users without central air conditioning units are reported to be equipped with a number of cabinet type air conditioners only in the electronic building.

1. if the heat load of the user workshop is larger, it is hoped that the cold humidification method should be used.

For example, the user has pure water or deionized water.

- recommend the use of ultrasonic spray and humidification

2) if the user has no pure water.

- suggestion to use wet film cabinet humidifier

2. if the heat load of the user workshop is small, it is hoped to use the hot humidification way:

A suggestion of using electric heating or electrode humidification!


Previous: Industrial dehumidification, moistureproof, mildew proof and anti oxidation knowledge

Next: Application of humidifying system in tobacco industry